LED Tape 12v 14.4w/m IP20 RGB

A very high lumens, 5m length of 14.4 watts per metre, 12v RGB(red,green,blue) LED strip with self adhesive backing for easy installation.
The tape uses the highest quality Epistar SLB LEDs which means that it gives up to a 70% energy saving compared to conventional LED strip..
The tape has a white backing colour to give an unobtrusive appearance and is 10mm wide.
The strip has a very low light depreciation of just 3% after 30000 hours.
This tape is the highest quality commercial grade made to exacting manufacturing standards as detailed below:-

• Specialise LED binning system to ensure that customers receive high consistency in the LED light colours
• 99.99% gilded wires to improve the stability and longevity of the LEDs.
• Utilises phosphors with rare earth aluminates for minimal colour shift.

The light output details are most impressive as below. This may seem complex but please note with RGB strip you cannot simply specify a lumens output value:-

• Color Temperature Red: 620-630nm, 500mcd
• Green: 520-530nm, 950mcd
• Blue: 465-475nm, 220mcd

The tape is suitable for dry areas and carries an IP20 rating.
This RGB tape can be controlled by a standalone RGB Tape Controller and a 12v power supply. Alternatively it can be controlled through a master DMX controller or lighting automation system which has a DMX output then using a DMX Decoder in conjunction with a 12 volt power supply .In this configuration the 12v driver should be of a larger wattage rating than the tape being driven. Here are some compatible 12v drivers.
The tape is supplied in a 5m roll and can be cut to the desired length along the prescribed cut marks. Connectors are then available from the accessories section to wire up the cut lengths.
If you need shorter lengths or would like to take advantage of our service to make up to specific lengths with soldered leads please call us at SLB on 01420 520521.
Any questions on the LED Tape or how to wire up please ask.